Cal-Centron Banner
Home Page Link Button
Product Info Link Button
Philmore Home Page | ST Series U/D Transformers | Multi-Pin Mobile Connectors | HDMI Cables | Self-Fusing Tape
 
Self-Fusing Silicone Rubber Insulation Tape
 

Philmore Self-Fusing Silicone Rubber Insulation Tape, PHILMORE S/I TAPE

  • INSULATE CONNECTIONS
  • REPAIR WIRE INSULATION
  • SEAL OUTDOOR ANTENNA CONNECTIONS
  • APPLY GRIPS TO HAND TOOLS
  • BUNDLE WIRES FOR HARNESSE
  • WEATHERPROOF RF CONNECTORS
  • SEALING, INSULATING PIPE or ELECTRICAL CONNECTIONS
  • THOUSANDS OF USES...

UL LISTED
LISTED
Meets UL standard 510
Meets or Exceeds U.S.
MIL Spec. AA-59163

 

Philmore Self-Fusing Silicone Rubber Insulation Tape, PHILMORE S/I TAPE Example of Uses
Philmore Self-Fusing Silicone Rubber Insulation Tape, PHILMORE S/I TAPE Example of Uses
Philmore Self-Fusing Silicone Rubber Insulation Tape, PHILMORE S/I TAPE Example of Uses
Philmore Self-Fusing Silicone Rubber Insulation Tape, PHILMORE S/I TAPE Example of Uses
 

S/I TAPE can SEAL and INSULATE and may also be used to create a non-slip GRIP on the handles of your tools. There is no sticky adhesive; S/I TAPE is a fusion tape that chemically and physically bonds to itself wherever it over-laps!

S/I TAPE has some marvelous properties. S/I TAPE is waterproof and can withstand temperatures for -65° F (below zero) to 500° F. S/I TAPE (outdoor) can be wrapped around coax at the base of the connector for years of (outdoor) protection. And S/I TAPE can withstand the sun's ultra-violet!

S/I TAPE may be used to cover an exposed conductor in a damaged extension cord and works just a well to cover a spurt in the middle of a garden hose or water pipe. Simply wrap the tape around the pipe or wire that you need to protect, overlapping as you go. S/I TAPE will grip immediately and achieve complete bonding and sealing within 24 hours at room temperature.

S/I TAPE is a silicone based product that is a wonder of modern chemistry. Don't mistake it for old fashion electrical tape; that plastic stuff with gummy adhesive on on side, S/I TAPE is self-fusing; wrap the first turn 100% coverage and then overlap each turn covering from 30% to 50% appx. of the previous turn.

 

Tape Specifications:

  • Operating temperature range: -65°F to 500°F, Dielectric Constant @ 1KHz. 2.95
  • Dielectric Strength: tested to ASTM D-149, when stretched/layered to .0" thickness 300 volts/mil.
    • Volume Resistively: tested to ASTM D-257 3X1014 Ohm/cm
  • Tensile Strength: tested to ASTM D-412 700PSI, Tear Resistance: 85 PSI
  • Hardness: 50 shore durometer.
  • Roll Size" 1" x .020" thick x 10 feet length.
  • Resists: UV, Oil and Chemicals.
  • Insulates: 8,000 Volts per Layer.
  • Note: over-lapping does increase dielectric strength

PHILMORE S/I TAPE™
Only $7.50 per roll

  • 12-3402 - Black
  • 12-3404 - Clear
  • 12-3406 - Red
  • 12-3408 - White
  • 12-3416 - Green
  • 12-3410 - Blue
  • 12-3412 - Grey
  • 12-3414 - Yellow
  • 12-3418 - Orange
 

Please contact Cal-Centron for additional Information.

Search Engine  |  Special Offers | Closeout Specials   |  Newsletter Signup  |  E-Mail 
  Terms and Conditions  |  Company Info  |  About Us  | Locate Us  |  Need-To-Know

Copyright © 1999 - 2014 Cal-Centron. All rights reserved.